All the configurations is in the Signblazer software and your computer. The model number shouldn't matter, it takes the same driver. As I noticed, the CT is for 24 inches cutting area, my plotter display says.
I changed the serial parameters in the program but in the plotter display, I don't find the configuration section to. I downloaded the sginblazer and the program is OK. Go on Ebay or other electronic store and find the 25 pin cable. Please, somebody help me, because during the last 2 weeks I spent a lot of hours trying to setup this cutter with no luck. I have a pc ik intel processor, 4gig of memory, 1 tera of capacity and Windows-7 installed. I suppose that the ct is a 48 inches cutter, right? Here are the some issues that I noticed in this cutter. Two weeks ago, my mimaki plotter died and I tried to install the ct with no luck. I purchased as a backup cutter and never used it. Hi to all I have a ct for the last 3 years.
